INTRODUCTION

In todays tutorial, we will make a Snake maze game using a 16*2 LCD and PS2 Joystick module with Arduino Nano. This is one of the most popular games of our childhood. This project is based on a 16*2 LCD, which gives a little room for a snake.

HARDWARE REQUIRED

• Arduino Nano-1pc
• USB Cable – 1pc
• LCD 16*2 Display – 1pc (yellow)
• Joystick Module – 1pc
• Jumper Wire (Male to Male) – 40pcs
• Jumper Wire (Male to Female) – 40pcs
• Potentiometer 10k – 1pc
• Breadboard 400 Points – 1pc

SOFTWARE REQUIRED

Arduino IDE 1.8.10 (programmable platform for Arduino)

Click here to download the software

SPECIFICATIONS

Joystick Module:

• 5V/3.3V Compatible
• Analog Output

Arduino Nano:

• DCCurrent Per I/O Pin: 40 mA
• Digital I/O Pins: 22
• Operating Voltage: 5VDC

16*2 LCD Display:

• 5V power supply ( Also available for +3V)
• Negative voltage optional for +3V power supply

CIRCUIT CONNECTION

Arduino Nano to Joystick:

Arduino Nano to LCD:

To connect multiple GND and 5V wires soldering may be required or you can use a breadboard.

CODE

Run the code given below and play the game.

Click to open in Drive

WORKING AND OUTPUT

Welcome to the Arduino-based project.

After uploading the code, you will see a Level 1 Python Content. Now start to play. It has 4 levels in the code you can change the level of the game, and if the tail and the mouth of the snake touch, then the game will be over, but if you complete the level, then you will be automatically redirected to the next level.

DOCUMENTS

KT877 – Click to open